Focaljet - Ford Focus Forums - View Single Post - EEC-V pinout V.2

**goinloco1** · 09-27-2006, 02:47 AM

according to the ford shop manual the svt engine is actually listed there as a duratec st. why i have no clue...

also, pin 48 is a clean tach signal. no need to install a tach driver under the hood. strip about 1/4 off the end of your wire and slip it into the hole pressing it in firm, then tape to other wires to keep it firmly in place.

09-27-2006, 02:47 AM	#5
goinloco1 Junior Member Join Date: Apr 2004 Posts: 99	Re: EEC-V pinout V.2 according to the ford shop manual the svt engine is actually listed there as a duratec st. why i have no clue... also, pin 48 is a clean tach signal. no need to install a tach driver under the hood. strip about 1/4 off the end of your wire and slip it into the hole pressing it in firm, then tape to other wires to keep it firmly in place.