The Ford Focus Forum | Powered by Focaljet - View Single Post - Suzuki GSXR 750 quad Throttle Body Install on 2.3 L Duratec

**JohnStranahan** · 08-23-2008, 04:40 PM

Jon.k-Not sure what is wrong or what needs explained?

There is a rough schematic drawing of the manifold earlier in the thread. Don't really know if it is going to work well yet. Getting closer. Probably will be a Christmas install to test it. I purchased the large vaccuum barbs, 3/8 hose x 1/4 pipe. These have about a 1/4 inch hole. Installed through the bottom of the plastic manifold they will supply sufficient flow to keep a good vacuum in my vacuum tank. This is all to feed the combined MAP/Temperature sensor values close to what the stock engine manifold provides it.
John

08-23-2008, 04:40 PM	#192 (permalink)
JohnStranahan Junior Member Join Date: Dec 2004 Posts: 98	Re: Suzuki GSXR 750 quad Throttle Body Install on 2.3 L Duratec Jon.k-Not sure what is wrong or what needs explained? There is a rough schematic drawing of the manifold earlier in the thread. Don't really know if it is going to work well yet. Getting closer. Probably will be a Christmas install to test it. I purchased the large vaccuum barbs, 3/8 hose x 1/4 pipe. These have about a 1/4 inch hole. Installed through the bottom of the plastic manifold they will supply sufficient flow to keep a good vacuum in my vacuum tank. This is all to feed the combined MAP/Temperature sensor values close to what the stock engine manifold provides it. John