Thread: offset HELP!?
View Single Post
Old 03-16-2009, 02:37 AM   #15 (permalink)
Z63R
Official [FJ] Distinguished Advisor
 
Z63R's Avatar
 
Join Date: May 2004
Location: El Lay Ca
Posts: 22,829
Default Re: offset HELP!?

^ Thank you, my good man; you do indeed have the tire & wheel specs correct, but the car's been sitting on H&R Sports and KYB AGXs for over two years now.



Sits a little higher in the back due to the 58 pounds of rear seats, seatbelts, anchors, hardware and rear wiper motor deletion. Sits a tad higher in the front due to the all-alloy Duratec engine.

A full-interior Zetec-engined ZX3 would sit a bit lower all around on those H&R Sports.

Here's the car going down the road after the rear seat delete, with some junk in the trunk; about 60 lbs to be exact...

__________________
.
"I replaced the battery cables to the starter. I've been dreading it since the PowerWorks severely restricts access to the starter... A good job for a 6'2" 150lb pianist, but not so hot for a 5'10" 220lb wookie. - OmniFocus

2.3 Duratec ZX3 + some bits
Z63R is offline   Reply With Quote