Camber plates... 2010 version.

[COSVT03]

My enigne wont be built until then So I must not be in as much of a hurry as you guys! But seriously. Update please. I have been looking for a set for a year now. Called 3 times.

[supersonicsvt]

LCR -

One of my street plates has now barfed the blue isolator around the bearing. The strut rod is now pushing thru the plate. This plate has about 5000 miles on it.

Could you PLEASE update us on the replacement plates?

[Deaner]

Last they were acive on FJ was:
Last Activity: 10-05-2010 12:33 PM

You might have to call them, but good luck doing so.

[Capaldi_PartsGuy]

Sorry I haven't been on guys. We are here M-F 8am to 5pm est. We ALWAYS have someone on the phone during those times. I have listed all my contact numbers here as well. Ill be more active on here again soon. We have quite a bit of new projects going on including this.

[theindustrialist]

Can we still expect a revised product or a working prototype by years end?

[Capaldi_PartsGuy]

I was hoping by year end but I cant promise that. The ST-R took over the shop... I was sworn to secrecy so I really haven't posted on here at all... Im sorry guys I just couldn't risk it.

The design revisions are all being looked at. I can tell you that the 2012 was directly responsible for the delay. You'll need to to read that last line, between the lines.

[theindustrialist]

Sadness.

[supersonicsvt]

Leo,

Here's another bit of data that might be useful as you consider the design revisions. My bottom plates were both bent. The 20-25 ft-lb torque on the mounting bolts deformed the bottom aluminum plate where there was no sliding plate between them. I'm guessing you used 6061-T6 Aluminum - steel of the same thickness deflects a lot less and is stronger - it would not have deformed.

So there's another reason to go with a steel lower plate............

[CorKey723]

Does anyone have any updates on these. Was gonna consider these for spring when the drop goes back on.

[Deaner]

Any updates?

[focusedaddiction]

any new updates ? i need some race plates by april '12 for autoX. thanks steve

[thielt1]

I will also be in for a set of these!

[SVT3658]

It's almost 2012 ... will we ever see the 2010 version of these?

[mattellermets]

Leo,

Here's another bit of data that might be useful as you consider the design revisions. My bottom plates were both bent. The 20-25 ft-lb torque on the mounting bolts deformed the bottom aluminum plate where there was no sliding plate between them. I'm guessing you used 6061-T6 Aluminum - steel of the same thickness deflects a lot less and is stronger - it would not have deformed.

So there's another reason to go with a steel lower plate............

+1 I have had to straighten mine twice now.

[thielt1]

Are you guys going to make these soon?!?!?!

[SVT3658]

Are you guys going to make these soon?!?!?!

yeah, what he said

[toshindo]

Unless you call and update us then we'll probably never hear anything. They are pretty irresponsible when it comes to following up on their forum. Personally think they should be removed but that's just my opinion.

[Dr0ppdOOh9]

I tried calling their shop last week and I kept getting their voicemail.

[thielt1]

did you ever get a hold of them?

[mattellermets]

I think we are going to have to rename these plates the 2011 version, no update since 2 months ago

Make that 2012... or will it be 2013... lol