2009 Drag Times

[Bwinkelsas]

my newest quarter mile time, last friday was at orlando speed world, i was having trouble launching. but my best run was as fallows.

60' - 2.362
330' - 6.322
1/8 - 9.467
mph - 78.88
1000' - 12.188
1/4 - 14.484
mph - 98.08

i need a lsd, and a clutch (stock), thats on a 75 shot


and iceguy! im ready to see some new numbers from the build i have seen / read!!!

[iceguyb14]

Originally Posted by Ja-Red

not really the mph has more to do with Hp and less with 60' and launch. A friend of mine actually ran less mph the faster his 60' got (low 11 sec integra)

it depends on how much you have to lift. before i ran 105.21 with a 2.59 60' and with a 2.277 i ran a 103.02. but i have to lift a LOT now which is why. i didnt get as much wheelhop before and i didnt care as much

and yeah bwinkelsas im looking forward to some new #s as well!

[Ja-Red]

Originally Posted by Uncle Tail

ok, thanks fellas.

The car always squirms around in the 60' even if I only launch at like 1800 rpm. I have tried lots of air pressures, smokier, hotter burnouts, I have stiff mounts, etc., it is a factor of tires I think. The BFG's have 2 years on them, almost done now. I may try the Hoosiers next (as someone on here suggested).

I wondered about the Lentec trans brake, but at the same time, think I might try the 225/50/15 Hoosier as opposed to the 205/50/15 BFG's I am wearing currently. I have the "Saleen" Suspension Kit on the car, so about a 1.5 " drop. Do you guys fit a 225/50/15 ok in your wheel well with a drop?

What are your thoughts on transbrakes?

225/50/15 will def fit that is what I run. I too need some new ones. Im gonna try and revive them with a little track-bite for now.

[daveyboy]

Got a new fastest time last weekend

60'-2.403
330'-6.899
660'-10.619
660 MPH- 66.20
1000'- 13.803
1320'-16.464
1320 MPH-84.78

[happyhands]

This is with k&n cone only. I had some used Hydro Edge tires on it. Air down to 20psi... I was launching at 3500rpm... Now i have some diff. tires and got that ford curve fixed and a 2-step set at 3700rpm.. Im hoping for 10.00 flat... The slip says a 10.330 at 68mph..

[Ja-Red]

I guess I need to post my timeslip here too.

This was 16.5 psi or 305-310whp on old 225/50/15 BFG Drag radials@18psi best results were leaving on high boost 4800rpm 2step 3/4 throttle feathering it.




Here is what it reads:
Reaction: .092
I1: 2.096
I2: 5.584
I3: 8.345
MPH (I3): 88.235
I4: 10.641

E.T.: 12.712
MPH: 113.467

[happyhands]

Thats some nice numbers Ja-Red..How does that 2-step work for you?

[Ja-Red]

Good, but you have to unhook the clutch pedal position sensor to keep the motor from bogging in between shifts.

[happyhands]

Yea i found that out after I got mine. I just pushed the gray plastic piece up and made it stay there. So yours is disconnected? If so did it throw a light? If not how did you do it? When i disconnected mine. The car would just rev to were my 2-step was set at..

[Ja-Red]

No light and it only works when the car is sitting still, which is were I want it. The only thing is that the cruise does not work. I think I am going to hook a toggle switch up to it So I don't have to keep getting under the dash every time I go to the track.

[Liquid_02_ZX3]

Muncie Dragway

4/SEP/2009

60' --- 2.312
330' ---6.701
1/8 --- 10.308
MPH --- 67.93
1000' --- 13.420
1/4 --- 16.066
MPH --- 85.29

Full interior, 1/2 tank of gas, 240lb driver, with a fried o2 sensor.

[knowhimwell]

Zmax Dragway Charlotte, NC - Nov. 3, 2009
GOOD-
ZX3 w/ JRSC
BBK
ODP
Full Exhaust(no cat)
WMI
67mm TB
BAD-
240lb Bad Driver(ME)
40lbs in K106 Kuhmo tires
hot stock clutch(my fault from 2 runs earlier)
Full Interior
1/2 tank of gas
1st time I have been on the track in 10 years

R/T - .191
60' - 2.364
330' - 6.309
1/8 - 9.538
MPH - 74.87
1000' - 12.303
1/4 - 14.700
MPH - 94.78

[Uncle Tail]

looks good what's the altitude in Charlotte?

[happyhands]

Ive been wanting to go to Zmax. Im about 2 hours west of there. "knowhimwell" if you go again soon let me know. I go Shady Side drag way close to S.C.

[knowhimwell]

Originally Posted by happyhands

Ive been wanting to go to Zmax. Im about 2 hours west of there. "knowhimwell" if you go again soon let me know. I go Shady Side drag way close to S.C.

The track is nice. I was disapointed in traffic flow backstage. There is no good way to get to the staging area from outside, Go to their website, it tells when street-racing days are. It cost $20 for car and driver and everyone else is $5 each, under 12 are free. Good Deal, I think.

[CWCZX3]

Last night at Cecil County Dragway

R/T-.102
60'-1.983
330-5.613
1/8-8.541
MPH-84.55
1000-11.099
1/4-13.243
MPH-105.49

[CTZX3]

Guess I need a Turbo