1. Remove the 4 screws from the top and pop out the bases, two more on the bottom:

2. Jack up the rear end and pull off the wheels, remove the fastener holding the wheel well in place, then pull it back and remove the other two fasteners:




3. Wrestle the rear fascia off and remove the 11 fasteners holding the SVT diffuser in place:

4. I would recommend fitting and clamping the diffuser in place and then marking the spots to drill. Drill into the 4 BIGGEST tabs in the diffuser and corresponding spots in the fascia:


5. The tabs on the diffuser fold over and attach to the fascia like so:





6. I used some sheet metal screws in the 4 tabs (some reuse the screws from the SVT grille) and then 1.25" screws and speed nuts on the outside tabs. I re-used some of the push pin fasteners on the two inside folded over tabs (couldn't get the screws back in though.):



7. Wrestle the rear fascia back on, re-install the fasteners (you'll have some leftovers now) and enjoy:




As a note, if you've never used the black fasteners, you can pop the "base" in and then push the "screw" back in. All in all, I'd say it took me 3-4 hours after getting the fascia off, lining everything up, drilling the holes, lining everything back up, redrilling the holes, etc. I hope I didn't oversimplify it for anyone.
Good luck and I hope you enjoy.









Linear Mode
