SVT blow by?

[TfnG]

is there anyone else out there with a SVT spec focus? just wondering if anyone else gets a lot of engine oil in their air box? i got out on track over the weekend for the first time and looks like i need a catch can of some sort.

[Egz]

From the SVTs I know on track, some boosted, some mostly stock, that they almost all do that.

[BadIdea]

They all do it. Catch can or I have the steeda elbow that connects after the mass air sensor.

[Blkmamba]

I would get quite a bit of oil out of the crankcase auto- X ing and at track days. It got so bad it would get on the MAF housing and on the hot wires of the MAF itself!
My setup is all motor and close to SPEC as i am practicing HPDEs to hopefully run the series. As you can see my crankcase vent is straight to the intake. that was the source of the blow by. We really need to look into this more and we might get someone in the know.

The air-water catch on my battery box is is hooked up to take from my PCV valve and send the clean gasses back to the intake manifold. after this can was put in, i dont have any problems on the Track or at hard day of test. The hose from the cranckcase is clean and i take off the MAF housing every now and then and it is clean. The only question is if the catch put less pressure on system all together or is the crankcase and PCV totally have nothing to do with each other.

[TfnG]

where do u find that steeda MAF part? it looks perfect...but i dont see it on their site.

[BadIdea]

http://www.steedafocus.com/store/Fue...duct_info.html

Someone is always selling a used one. They are really affected by heat so I just use the elbow, then it goes to bmc filter intake.