OK For my next focus, i dont want the sysrem i had previously. I want something like the mach or svt setup.. Preferably the MACH..
I was thinking of just getting a regular ZX3 and rigging the MACH system into it.. Only question is, like the SVT's audiophile, i dont have a clue how to read the wiring harnesses that are used in the system.. i have seen the mach system, and there are a total of 18 wires to worrie about, 9 on each amp!!! 3 thick red, 3 Thick Black and 3 thinner ones, 1 Silver w/ black stripe, 1 white with red stripe and 1 white w/ black stripe....
My thoughts are as follows: IF the regular speakers run off of the deck power, then :
1) The 2 AMPS use the 3 Thick red and 3 thick Black to power and ground (respectivly). then 2 of the thin are audio inpute and the last little wire (probably) the lone white w/ red stripe is the remote ..... ??? [img]images/icons/confused.gif[/img] [img]images/icons/confused.gif[/img]
Any Ideas? i would think that the amps would need more than just 1 single 14? Ga wire to power... Iv heard good things about the mach and altho i dont want a sadan, i do want a compact sub amp setup.. thanks for any infor or imput you may have!!! Steve [img]graemlins/thumbup.gif[/img]
[size="1"][ 10-08-2002, 08:52 PM: Message edited by: S2r ][/size]